Engineering solutions in the field of
lubricants and sealants



Lubricants for antifriction bearings and plastic and rubber parts.

Operating temperatures

-73°C +204°C


  • Applications
  • Friction units
  • Advantages
  • Problems to be solved with this material
  • Recommended by manufacturers
  • The combination of materials
  • Features



Resistance to oxidation, moisture and corrosive atmospheres
Good shear stability
Wide service temperature range: -100 to 400°F (-73 to 204°C)
Compatible with many plastics


Freezer cart casters and cold room conveyor equipment
Utility disconnect switch contacts
Plastic electric clock motors
Maximum-demand meters, power-factor meters, watt-hour meters
Windshield wiper motor gears
Photographic, optical and surveying equipment
Oscillographs, geophysical and light, low-torque instruments
Starter clutch drives

It is used in friction

  • Rolling bearings
  • Sliding bearings
  • Sliding guideways
  • Enclosed gears
  • Open gears
  • Cased control cables
  • Gaskets


  • Cold resistance
  • Termal (heat) resistance
  • Working capacity in moisture
  • Good anticorrosion properties (good corrosion protection)
  • Good water washout resistance
  • Long service life
  • Good shear stability at low temperatures
  • Compatible with many plastics
  • Compatible with many elastomers

Problems to be solved with this material

  • Corrosion
  • Lubricant wash-out
  • Frequent re-lubrication
  • Plastic and elastomer details deformation and destruction

Recommended by manufacturers

  • Fire lite alarms
  • KTM Sportmotorcycle
  • Tyco

Material combination in friction pair

  • Metal - Metal
  • Metal - Plastic
  • Metal - Elastomer
  • Plastic - Plastic
  • Plastic - Elastomer
Стандарт Показатель Ед. изм. Значение
Базовое маслоСиликоновое
ЗагустительЛитиевое мыло
Диапазон рабочих температур°Сот -73 до +204
Фактор скоростимм*об/мин≤250000
DIN 51 562Кинематическая вязкость базового масла при 25 °Смм2/c100
ASTM D 217Пенетрация перемешанной смазки (60 циклов)мм/10320
DIN 51 818Класс консистенции по NLGI1
ASTM D 2265Температура каплепадения°C226
ISO 2811Плотность при 25 °Сг/см30,97
Fed Std 791Выделение масла (24 ч, 150 °C)%2
DIN 51 817, Fed Std 791-32/2Выделение масла (168 ч, 40 °C)%3,2
DIN 51 350 pt.4 Нагрузка сваривания (испытание на четырехшариковой машине трения, 1450 об/мин/10 с),Н1200
ASTM D 1478-80Момент сопротивления вращению подшипника качения при пониженной температуре -73 °С при запуске / через 20 мин после запуска / в рабочем режимеH*м0,130/0,013/-