Engineering solutions in the field of
lubricants and sealants

Materials: Molykote
Paste Molykote M-77


Silicone based MoS2 paste.


Material Safety Data Sheet - Molykote M-77 Technical Data Sheet - Molykote M-77

Operating temperatures

-45°C +350°C


1kg 20kg
  • Applications
  • Friction units
  • Advantages
  • Problems to be Solved material
  • Recommended by manufacturers
  • The combination of materials
  • Features



Paste lubrication up to +230°C (+446°F), dry lubrication up to +450°C (+842°F)
Good water resistance
Good volatilization properties
Compatible with many types of elastomers and plastics (test for compatibility)


Suitable for lubrication points with low to moderate loads and low speeds which are subjected to water and extreme temperatures. At temperatures above 230°C (446°F), the carrier volatilizes leaving virtually no residue, and the remaining dry sliding film itself takes over the lubrication up to +450°C (+842°F)
Suitable for lubricating parts consisting of materials that are not resistant to mineral oils
This product is used successiully on metal/metal combinations with frictional and contact surfaces, brake anchor plates and the brake pistons of disc brakes.

It is used in friction

  • Sliding bearings
  • Interference fits
  • Strips
  • Spline / key joints


  • Cold resistance
  • Termal (heat) resistance
  • Working capacity in moisture
  • Emergency properties
  • Compatible with many plastics
  • Compatible with many elastomers
  • Avoidance of stick-slip

Problems to be Solved material

  • Seizure
  • Stick-slip motion
  • Frequent re-lubrication
  • Plastic and elastomer details deformation and destruction

Recommended by manufacturers

  • Acura
  • Emerson Process Management
  • Honda
  • Infiniti
  • Naval sea systems command
  • Nissan
  • Rover Company
  • Subaru

The combination of materials friction pair

  • Metal - Metal
Стандарт Показатель Ед. изм. Значение
Базовое маслоСиликоновое
ЗагустительЛитиевое мыло
Антифрикционные добавки (наполнители)Дисульфид молибдена
°СДиапазон рабочих температурот -45 до +230
°СВерхний предел рабочих температур твердых смазочных материалов, входящих в состав продукта+350
DIN 51 562мм2/cКинематическая вязкость базового масла при 25 °С125
DIN ISO 2137мм/10Пенетрация неперемешанной смазки280-330
ISO 2811г/см3Плотность при 20 °С1,95
DIN 51 350 pt.4ННагрузка сваривания (испытание на четырехшариковой машине трения, 1450 об/мин/10 с),2000