Engineering solutions in the field of
lubricants and sealants
+7 (495) 974-97-73
Рус Eng
Рус Eng


Buy

Description

Chain and open gear lubricant.



Operating temperatures

10°C +160°C

Pre-packing

400ml25kg49.8kg
  • Applications
  • Friction units
  • Advantages
  • Problems to be solved with this material
  • The combination of materials
  • Features

Applications

FEATURES

Emergency lubrication
High pressure resistance
High wear protection
Extremely adhesive
Resistance against water

APPLICATIONS

Used for initial lubrication of chains with hollow pins equipped with grease nipples. e.g. high tenter clamp chains in the textile industry and conveyor chains in food sterilizer units.
Also used for gear drives and open gears, sliding bearings operating at low speeds and high temperatures, such as bearings in drying systems and calendaring machines used in various industrial processes.

It is used in friction

  • Rolling bearings
  • Sliding bearings
  • Sliding guideways
  • Chains
  • Open gears
  • Cargo cables

Advantages

  • Termal (heat) resistance
  • Higher load carrying capacity
  • Working capacity in moisture
  • Working capacity in dust
  • Good adhesion strength
  • Good water washout resistance
  • No drop point
  • Emergency properties
  • Aerosol
  • Avoidance of stick-slip

Problems to be solved with this material

  • Seizure
  • Stick-slip motion
  • Dust intrusion into lubricating points and abrasive wear
  • Lubricant wash-out
  • Lubricants leaking off or emission due to centrifugal forces
  • Frequent re-lubrication
  • Lubrication points inaccessibility

Material combination in friction pair

  • Metal - Metal
Стандарт Показатель Ед. изм. Значение
—ЦветЧерный
—Базовое маслоПолиизобутилен
—ЗагустительНеорганический загуститель
—Антифрикционные добавки (наполнители)Твердые смазочные материалы: графит, дисульфид молибдена
—ПрисадкиУсилитель адгезии
—Диапазон рабочих температур°Сот +10 до +160
DIN 51 562Кинематическая вязкость базового масла при 40 °Смм2/c1500
—Пенетрация неперемешанной смазкимм/10250-280
—Класс консистенции по NLGI2...3
—Плотность при 20 °Сг/см30,95
DIN 51 350 pt.4Нагрузка сваривания (испытание на четырехшариковой машине трения, 1450 об/мин/10 с),Н2600
—Критическая нагрузка (метод Almen-Weiland)Н18000
DIN 51 350Показатель износа (испытание на четырехшариковой машине трения, 1450 об/мин/600 Н/1 ч)мм0,9
 

		

		
		
		
		

			
		

	

	
Яндекс.Метрика