Engineering solutions in the field of
lubricants and sealants


Buy

Description

Silicone based MoS2 paste.



Operating temperatures

-45°C +350°C

Pre-packing

1kg20kg
  • Applications
  • Friction units
  • Advantages
  • Problems to be solved with this material
  • Recommended by manufacturers
  • The combination of materials
  • Features

Applications

FEATURES

Paste lubrication up to +230°C (+446°F), dry lubrication up to +450°C (+842°F)
Good water resistance
Good volatilization properties
Compatible with many types of elastomers and plastics (test for compatibility)

APPLICATIONS

Suitable for lubrication points with low to moderate loads and low speeds which are subjected to water and extreme temperatures. At temperatures above 230°C (446°F), the carrier volatilizes leaving virtually no residue, and the remaining dry sliding film itself takes over the lubrication up to +450°C (+842°F)
Suitable for lubricating parts consisting of materials that are not resistant to mineral oils
This product is used successiully on metal/metal combinations with frictional and contact surfaces, brake anchor plates and the brake pistons of disc brakes.

It is used in friction

  • Sliding bearings
  • Interference fits
  • Strips
  • Spline / key joints

Advantages

  • Cold resistance
  • Termal (heat) resistance
  • Working capacity in moisture
  • Emergency properties
  • Compatible with many plastics
  • Compatible with many elastomers
  • Avoidance of stick-slip

Problems to be solved with this material

  • Seizure
  • Stick-slip motion
  • Frequent re-lubrication
  • Plastic and elastomer details deformation and destruction

Recommended by manufacturers

  • Acura
  • Emerson Process Management
  • Honda
  • Infiniti
  • Naval sea systems command
  • Nissan
  • Rover Company
  • Subaru

Material combination in friction pair

  • Metal - Metal
Стандарт Показатель Ед. изм. Значение
ЦветСеро-черный
Базовое маслоСиликоновое
ЗагустительЛитиевое мыло
Антифрикционные добавки (наполнители)Дисульфид молибдена
Диапазон рабочих температур°Сот -45 до +230
Верхний предел рабочих температур твердых смазочных материалов, входящих в состав продукта°С+350
DIN 51 562Кинематическая вязкость базового масла при 25 °Смм2/c125
DIN ISO 2137Пенетрация неперемешанной смазкимм/10280-330
ISO 2811Плотность при 20 °Сг/см31,95
DIN 51 350 pt.4Нагрузка сваривания (испытание на четырехшариковой машине трения, 1450 об/мин/10 с),Н2000

		

		
		
		
		
Яндекс.Метрика